If you like a warm, soft, pleasant ground beneath your feet, you need a carpet in your bathroom . You can line the entire bathroom or just a party to get the look and feel you want. By purchasing and installing remains the carpet yourself, you can save lots of money.
1 - Cover the carpet in the bathroom covering areas near the sink, bathtub and toilet. You want to cover areas that will touch your feet when you use the bathroom. Use small rugs that can be washed to keep the room clean and odorless.
2 - Install a carpet wall to wall rubber to insulate against moisture.
3 - Add borders, vinyl, laminated, marble or ceramic around your bathtub, toilet and sink to prevent water from spilling onto the carpet.
4 - Choose your color and measure the room before you begin. Choose a carpet that has a coating of rubber, foam strips and nylon low accumulation.
5 - Prepare the room before you start by sweeping or vacuuming the floor so it is clean. Install a sub floor dry, flat and stable to prevent moisture from accumulating. Glue or staple the underlayment to the floor. Attach to Using the tape where the sub-layers merge.
6 - Nail around the bathroom with the staples exiting from the wall to hold your carpet the ground.
7 - Cut the rug end to end so you can put the carpet down and fasten your toilet, bathtub and sink. Ask the carpet with the hair facing the door trim and carpet substantially to fit the room, leaving an inch around the edges to slide under the baseboard.
* Use carpet tiles instead of carpet because full you can replace damaged parts.
* You can simply install the carpet in the entrance to your bathroom to be away from water!
0 comments:
Post a Comment